Amana NTW5200T Technical Education page 42

4. To remove the motor:
a) Remove the pump from the motor (see
step 3).
b) Disconnect the two wires from the mo-
tor start capacitor terminals (see page
4-9).
c) Raise the locking arm and disconnect
the wire connector from the motor.
d) Remove the hex-head screw from
each of the two motor mounting spring
clips.
e) Support the bottom of the motor with
one hand to keep it from falling, and
pry the ends of the two spring clips off
the motor with a screwdriver (see the
round inset below).
Spring Clip Screws
Pry Off Spring Clips
Motor Wire
Connector
4-
f) Pull the motor away from the washer
until the motor coupler pins disengage
from the motor coupler isolator, and
remove the motor.
Isolator
Motor Coupler
g) Remove the following components
from the motor:
• Motor Coupler
• Rubber Motor Mounts (4)
• Cardboard Shield
Motor Mount
Motor Coupler