Amana NTW5200T Technical Education page 49

9. To remove the basket drive assembly:
a) Remove the agitator and transmission
(see page 4-13 for the procedures).
b) Remove the basket (see step 7).
c) Turn the clutch engagement cam on
the basket drive in a counterclockwise
direction while pulling the cam toward
you, and remove the basket drive from
the support assembly.
SERVICE NOTE:
• While the basket drive is removed, check
for shaft wear, using the procedure shown
on page 5-6.
Basket Drive Shaft
Clutch Engagement Cam
REASSEMBLY NOTES:
1. When you install the drive block on the
transmission shaft, make sure that the
two slots fit over the tabs of the shaft.
2. When you install the tub ring on the tub,
position the ring with the keyed (narrow)
locking tab slot, as shown.
Keyed Locking Tab
4-
Drive Block Slots