Installation
The Router may be reset to the original factory default settings through the following actions.
1.
Press and hold the reset button while the device is powered off using a paper clip or similar object.
2.
Turn on the power and the router will restart. Observe the
3.
Wait for 5~8 seconds and then release the reset button.
4.
The device settings will be restored to the factory default IP address
255.255.255.0. The default username and password is admin and admin.
Note: A factory reset will erase the current configuration settings and reset them to the default settings.
After restarting your DSL-500B ADSL Router, log in to the router's web-based interface and use the Setup Wizard
to configure the basic settings.
D-Link DSL-500B User Manual
Factory Reset
Power LED to verify.
192.168.254.254 and the subnet mask is
19