Elation POWER SPOT 700CMY User Manual page 23

Power Spot 700CMY™
DFSE
FEED
EFLG
8.1 Setting/Changing the DMX Address
After applying power to the POWER SPOT 700CMY™ the LED will display the
fixture's current DMX address immediately after the reset sequence. If the fixture i s
not receiving a DMX signal the display will flash continuously.
D001
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the POWER SPOT 700CMY™ and wait for the fixture reset process to
finished ('RESE' will flash in the LED while fixture is in reset mode).
2. Press the Mode button to access the main menu. Toggle through the menu by
pressing the Up and Down buttons until the display shows D001. Tap the enter
button to make changes to the address, the current three digit address will
immediately begin to flash.
3. While the current three-digit address is flashing, use the Up and Down buttons
to select adjust the address. Lock your new address into the unit's memory by
pressing the Enter button. After the new address has been successfully stored
into the fixture's memory the LED will briefly readout OK.
©Elation Professionals® Los Angeles, Ca.
CL1f Fine calibration of color wheel 1 (CTO)
GOB1 Calibration of gobo wheel 1
GOB2 Calibration of gobo wheel 2
SHSC Shutter moves pair wise open and close
SHOC Shutter moves pair wise parallel left and right
Calibration of frost filter A
FR U
Calibration of frost filter b
FR O
Calibration of prism wheel
PRIS
IRIS Calibration of iris
FOCU Calibration of focus
POFS Calibration of Pan-Offsets
TOFS Calibration of Tilt-Offsets
CLRE Settings in the internal memory (super-user only)
SPFS Speed fast - limit the max. Pan velocity to 70%
Adjust Reset (all wheels stand still after a reset)
ARES
Call on the default function values
Pan/Tilt feedback (error correction) On/Off
Correction of faults
- wwww.ElationLighting.com - Page 23