Chevrolet Colorado 2012 Owner's Manual page 106

3-58 Seats and Restraints
The lap belt would be used to
secure a child restraint in this
position, following the instructions
that came with the child restraint.
1. Adjust the driver seat to the
desired position. Fold the
armrest up, if equipped.
2. Move the passenger seat so that
the seat and seatback are
aligned with the driver seat and
seatback positions. See Seat
Adjustment on page 3 3 or
Power Seat Adjustment on
page 3 3 and Reclining
Seatbacks on page 3 4 for more
information.
3. Make the center position lap belt
as long as possible by tilting the
latch plate and pulling it along
the belt.
4. Place the child restraint on
the seat.
5. If the child restraint manufacturer
recommends using a top tether
anchor, attach the top tether on
the child restraint to the top
tether anchor on the vehicle.
Route the top tether according to
the child restraint instructions
and the following instructions:
5.1. Pull on the finger access
tab to remove the cover to
access the top tether
anchor.
5.2. Route the top tether over
the center seatback or
folding armrest, if equipped.
I n f o r ma t i o n P r o v i d e d b y :
5.3. Attach the top tether to the
slots in the back panel as
shown.
Do not tighten the top tether
at this time.
6. Pick up the latch plate on the
center position lap safety belt,
and run the lap safety belt
through the restraint. The child
restraint instructions will show
you how.