Chevrolet Colorado 2012 Owner's Manual page 100

3-52 Seats and Restraints
2.2. Route the top tether (A)
through the loop (B) at the
top of the seatback to
attach the top tether to the
nearest top tether
anchor (C).
3. Tighten the lower anchor
attachments and the top tether.
The child restraint instructions
will show you how.
4. Before placing a child in the
child restraint, make sure it is
securely held in place. To check,
grasp the child restraint at the
LATCH path and attempt to
move it side to side and back
and forth. There should be no
more than 2.5 cm (1 in) of
movement for proper installation.
Right Front Seat Regular/
Extended Cab without Rear
Seats
The vehicle has a right front
passenger airbag and may also
have a passenger sensing system.
If the vehicle has a passenger
sensing system it is designed to turn
off the right front passenger frontal
airbag when an infant in a
rear-facing infant seat or a small
child in a forward-facing child
restraint or booster seat is detected.
See Securing Child Restraints
(Right Front Seat Position) later in
this section and Passenger Sensing
System on page 3 27 for important
safety information and additional
information on installing a child
restraint in the right front seat
position.
1. See Securing Child Restraints
(Right Front Seat Position) later
in this section for instructions on
installing the child restraint using
the safety belts.
I n f o r ma t i o n P r o v i d e d b y :
2. If the child restraint
manufacturer's instructions
recommend that the top tether
be attached, attach and tighten
the top tether to the top tether
anchor. Refer to the child
restraint instructions and the
following steps:
2.1. Pull the seatback forward to
access the top tether
anchor. See Seatback
Latches on page 3 6.
2.2. Pull on the finger access
tab to remove the cover to
access the top tether
anchor.