Appendix - Inter-m IMX-824 Operation Manual

MIXING CONSOLE

Appendix

Appendix
A) LAMPS
The lamp connector is a 4-Pin XLR-type connector (only pin 3 and pin 4 of the connector are used).
The total current available from each connector is 500mA (6W/12V).
Please visit the Littlite ® website for more information at: http://www.littlite.com
If the bulbs need to be replaced use only the following approved types as designated below:
Type 1815 2.4W/12V standard bulb (rated life of 1000 hours)
Type Q5 5W/12V 3800mA halogen bulb (rated life of 240 hours)
B) Changing signal flow via jumper settings
You may modify the standard signal flow in certain areas of the console based on user preferences.
a) Signal source for DIRECT OUT on mono channels
The internal signal source (as shipped from the factory) for the DIRECT OUT on each mono channel is
"Post-Fader." By selecting appropriate internal jumper settings the configuration may be changed in the
field to accommodate the special needs of the user. Alternate jumper settings for the internal signal source
for the DIRECT OUT are "Pre-Fader Pre-EQ" and "Pre-Fader Post-EQ."
b) Signal source for AUX SEND PRE switch on mono channels
As shipped from the factory, on each mono channel the signal source for the AUX SEND PRE switch is set
"Pre-Fader Post-EQ." By changing a jumper, this may be changed to "Pre-Fader Pre-EQ."
c) Muting of AUX SEND PRE on mono channels
As shipped from the factory, the AUX SEND PRE signal is muted when the channel MUTE switch is
activated. This may be changed so the AUX SEND PRE signal is not muted when the channel MUTE switch
is activated by changing the position of an internal jumper from the standard setting of "YES MUTE" to the
user preference of "NO MUTE."
28
IMX-824/832/840
J8
J7
d) Stereo Input AUX-Pre MUTE
Aux pre signal is normally muted by pressing the MUTE switch. If you don't wish to mute the signal, change
the jumper from "YES MUTE" to "NO MUTE".
J8
J7
AUX Pre MUTE
Yes
No
AUX Pre MUTE
Yes
No