Advertisement
Advertisement
Table of Contents
Related Manuals for Inter-m CA-5115D
Summary of Contents for Inter-m CA-5115D
- Page 1 CA-5115D/CA-5130D Powered Mixer Copyright 2004 Inter-M Corporation...
-
Page 2: Table Of Contents
Welcome ... 3 Unpacking ... 3 Warnings ... 3 Operation... 5 Features ... 6 Front Panel Controls... 7 Rear Panel Controls ... 10 Connections... 12 Block Diagram ... 13 Specifications... 14 Contents... -
Page 3: Welcome
A personal welcome to you from the management and employees of Inter-M Thank you for purchasing this fine Inter-M product. All of us here at Inter-M are dedicated to providing you with the highest quality products and the best value. - Page 4 CA-5115D/CA-5130D Powered Mixer 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades, with one wider than the other.
-
Page 5: Operation
CA-5115D/CA-5130D Powered Mixer Operation Make certain that speakers and input sources are properly connected before switching Keep volume levels at minimum gain and equalization set to 0dB position before switching on. When the AC Mains power switch is pressed, this unit starts operation with tuner display. -
Page 6: Features
CA-5115D/CA-5130D Powered Mixer Features Versatile and Powerful • Mic and line inputs accommodate a variety of input sources. Powerful 150W (CA- 5115D) or 300W (CA-5130D) power amplifier built in. Built-In Protection Circuitry • Integrated protection circuitry with LED indicators for overheating, speaker shorting and overload protection. -
Page 7: Front Panel Controls
Front Panel Controls 1. High EQ Controls These knobs control the associated channel’s high frequency equalization. This is a 10kHz shelving type EQ with a maximum cut or boost of ±15dB 2. Low EQ Controls These knobs control the associated channel’s low frequency equalization. This is a 100Hz shelving type EQ with a maximum cut or boost of ±15dB. - Page 8 –3dB before clipping. If the Peak Indicator is lighting frequently or glowing steadily, lower the channel’s input level. 7. EFX Master This knob controls the signal from the onboard digital signal processor (DSP). 8. Aux In This knob controls the signal level from the Aux Input, sent to the Master mix buss. 9.
- Page 9 This is typically due to overheating, a speaker short circuit or power limiting. Please check the Input and Output condition of the amplifier. 24. Power Indicator This LED indicator is lit when the CA-5115D/5130D is switched on.
-
Page 10: Rear Panel Controls
Rear Panel Controls 1. Power Switch This switch is used to switch the unit on and off. When the unit is on, the front panel Power Indicator LED (Front Panel Section #24) is lit. CAUTION: Reduce MASTER and MONITOR levels before switching the CA- 5115D/5130D on or off. - Page 11 CA-5115D/CA-5130D Powered Mixer 4. Fuse Holder This holder contains the AC overload protection fuse. If the fuse has blown out, replace it with a fuse of the same type and rating. If the fuse continues to blow, refer servicing to a qualified service technician.
-
Page 12: Connections
CA-5115D/CA-5130D Powered Mixer Connections CAUTION: When connecting devices to your CA-5115D/CA-5130D, avoid using non- standard plugs and cables. -
Page 13: Block Diagram
CA-5115D/CA-5130D Powered Mixer Block Diagram... -
Page 14: Specifications
Specifications Rated Output Power CA-5115D CA-5130D Frequency Response (0/-3dB) T.H.D. Distortion Mixer Channel Equalization High Graphic Equalizer (Master Section) Hum and Noise (EIN) Input Sensitivity Line Aux In EFX Rtn Output Sensitivity EFX Send Monitor Out Mix Out Phantom Power... - Page 15 Korea and China, and sales and marketing operations located in Japan, Europe, and the U.S.A. With more than 850 employees around the globe, Inter-M is well-poised for further growth and expansion.