Check Operation - KitchenAid 4329223 Installation Instructions And Use And Care Manual

Install chimney
sections
13.
Connect vent to damper or
hood and seal all connections with
duct tape.
upper chimney
screw
14.
Position upper chimney
section on support system frame and
secure with two screws.
upper
chimney
screws
lower
chimney
Fit lower chimney section over upper
chimney section. Note: clip hole
arrows must point toward ceiling.
Check for proper position. Then
secure upper and lower chimney
sections to support system frame with
four screws.
upper
chimney
trim
clips
support
lower
system frame
chimney
trim
15.
upper
chimney correct length. Be careful not to bend
strips while cutting. Slide clips into
trim. Postion to align with chimney
holes. Push trim strips so that clips
snap into holes.
16.
opening so rear edge is over flange.
Press filters up into position.
chimney
holes
chimney
clip
holes
trim
clip
Cut upper chimney trim to
Place filters in canopy

Check operation

17.
Turn power on.
control panel
location
18.
The island canopy hood
controls are located in a grey panel on
underside of the canopy. To open the
panel, press on the front edge of
panel and release. The control panel
will drop down.
blower speed
light blower
switch
switch switch
19.
Check the operation of the
range hood:
Move light switch to "1" position.
The light should turn on.
Move blower switch to "1"
position. The blower should
operate.
Move the blower speed switch to
the far left; blower speed should
be LOW. Move blower speed to
right; blower speed should
gradually increase until you reach
HIGH speed at far right.
Move blower and light switches to
"0" position to turn blower and
light off.
If range hood does not operate:
Check that the circuit breaker is
not tripped or the house fuse
blown.
Disconnect power supply. Check
that wiring is correct.
7