Destination Memory - Mercedes-Benz COMAND control panel Operating Instructions Manual

automatically highlighted in the selection
list.
If no home address has been stored yet, you
can now assign an address book entry. If a
home address already exists, it is displayed
and you can alter it.
i
If you select New Entry, you are also
offered the option of entering the home
address for the first time. You can then
save the home address without starting
route guidance.
To enter the home address for the first
X
time: select Assign to Address Book
Entry and press W to confirm.
Select Home or Work and press W to
X
confirm.
To change the home address: select
X
Change and press W to confirm.
Select Assign to Address Book Entry
X
and press W to confirm.
i
If you select New Entry, you are also
offered the option of changing the home
address by entering an address. You can
then save the home address without
starting route guidance.
Select Home or Work and press W to
X
confirm.
In both cases, you will see the address book
either with the character bar or as a
selection list.
To select an address book entry:
X
proceed as described in the "Searching for
an address book entry" section
( page 112).
Y
To confirm the selection: press W the
X
COMAND controller.
If no home address has been stored,
COMAND saves the entry. You will see a
message and then the address menu with
the selected address. Start
automatically.
If a home address has already been stored,
you will see a prompt asking you whether
the My Address
overwritten.
Select
X
If you select Yes, COMAND overwrites the
destination. You will see a message and
then the address menu with the selected
address.
automatically.
If you select No, the list will appear again.
Selecting the home address for route
guidance
Proceed as described in the "Selecting a
X
destination from the destination memory"
section (
Storing a destination in the

destination memory

Notes
This function also stores the destination in
the address book.
When the address book is full, no destinations
can be saved in the destination memory. You
must first delete address book entries
( page 113).
Y
After destination entry
The destination has been entered and is
X
shown in the address entry menu
( page 54).
Y
Select
X
cVd the COMAND controller and press
W to confirm.
You can now select storage options
( page 82).
Y
During route guidance
To show the menu: press W the COMAND
X
is highlighted
controller.
Destination memory
entry should be
Yes or No and press W to confirm.
Start is highlighted
page 57).
Y
Save by sliding VÆ and turning
81
Z