Service And Maintenance - Martin RoboScan 812 User Manual

s e c t i o n 4
S E R V I C E A N D M A I N T E N A N C E
Read the procedures carefully. If you do not feel completely
competent to perform the service, consult qualified service
Disconnect the fixture from power before removing any cover.
C h a n g i n g t h e L a m p
Martin P/N
Average Life
Color Temp.
Output
The three lamps shown above may be used in the RoboScan 812. Installing any other lamp
may damage the fixture. The lamp holder is adjusted at the factory; if further alignment is
necessary, the procedure is described on page 12.
1. Remove the 3 thumbscrews (10) securing the lamp-socket assembly to the
rear of the RoboScan. Gently pull out the assembly.
2. If changing the lamp, remove the old lamp from the socket.
3. Holding the new lamp in a clean cloth (do not touch the glass), carefully
insert it firmly and squarely into the lamp socket.
4. If your fingers touch the glass, clean the bulb with a clean, lint-free cloth
wetted with alcohol.
5. Replace the lamp-socket assembly and tighten the thumbscrews.
W A R N I N G !
personnel for assistance.
Martin 150 W
Metal Halide
97010107
2000 h
5000K
900 lm
Se rvice and Maintenance
Osram HTI 150
97010108
750 h
6500K
1200 lm
GE CSS 150
97010104
1000 h
5000K
900 lm
11