The Connected Devices Window; Part 2: Test Network Connectivity - Chauvet Nexus 4x4 User Manual

Operation
The Connected
Devices Window
Part 2: Test
Network
Connectivity
-22-
It can take up to 20 seconds for all the products to populate the list. The devices display in
different colors for different reasons, which are as follows:
Colors and Activity
Black with an ID number and IP
address
Green with an ID number and IP
address
Black to red with no IP address during
initial population
Black to red after initial population
4. Select the Output dropdown icon from the tool bar at the top of the Kling-Net Mapper
screen. One of the options will be Test Pattern.
5. Select Test Pattern. The image to the right of the icon is a small screen, indicating that
Test Pattern is the current mode.
6. Select the icon to the right of the Output dropdown icon. One of the options will be
Flashing Output Selection.
7. Select Flashing Output Selection. The icon is a faded green square with an arrow,
indicating that a flashing green light is the current test pattern.
8. Left click once on an LED display product. The product flashes green.
9. Repeat Step 8 for every product in the list.
Explanation
There is connectivity and everything is working properly, but
the device is not yet mapped.
There is connectivity and everything is working properly, and
the device is mapped.
The King-Net™ Mapper could not find an IP address for the
device, most likely because the system is using an Ethernet
switch instead of an Ethernet hub.
The connectivity has been lost.
Nexus™ 4x4 User Manual Rev. 4