Charging Method And Cautions - Art-Tech F-14 "TOMCAT" JET Instruction Manual

Charging method and cautions

Li-Po battery(balance changer)
ATI-0910 Li-Po battery(balance changer) specifications
Specifications:
Input voltage: DC 10V~15V
Output voltage: DC 7.4V & 11.1V (to 2 or 3 cell Li-Po battery)
Charging current: 0.3A~1.0A (can be continuously adjusted)
Indicator state:
Green: Charge complete & no battery
Red: Charging
Flash: Drip current charging
The batteries are inspected separately. When the voltage
reaches 4.20V, the charging process stops.
Operating
1. Then plug cigarette into its socket in car (Adapter should be
connected if charge at home: connect the adapter to home
power socket, then plug the adapter' DC end to charger). The
LED will turn green indicating it is ready for charging.
2. Connect the battery to charger per its interface mark. The LED
becomes red, which means charging is on the way.
3. Adjust the current among 0.3A~1.0A. In order to prolong
battery' life-span, we recommend to charge them under low
current if you have enough time.
4. When LED flashing, the charger will enter the stage of drip
current charging. The LED turns green when fully
charged , and the battery will be used at any time.
Notice
1. Do not insert anything conductive into the cooling hole when power is on, or damage will be caused to the charger.
2. While charging is in process, please do not make it near flammable materials.
3. It is not allowed to charge two-cell and three-cell Li poly battery at the same time.
4.Expect Li poly battery, this charger is not allowed for other kinds of battery.
5. While charging, please keep it out of the reach of Children.
6. When this charger is in use, please do not go away and leave it unwatched, if any abnormality occurs
(such as the power indicator is off, the temperature of the battery rise rapidly, etc.) stop charging immediately.
7. Please do not use power with output voltage higher than 15V.
8. Please do not disassemble the charger or its accessories.
9. When the battery is not cool down, please do not urge to charge it.
Notice
1.Be fully charged under no more than 1 A voltage by using the specified charger.
2.Be discharged under 10C voltage but avoiding discharge time too long to harm the battery.
3.Repeat the first and second step one or two times.
4.When the Li-poly battery was stored more than 3 months, it needs to be recharged to
maintain its voltage, and ensure its life time.
4
WWW.ART-TECH.COM
C
12V D Power supplier