Connecting The Ifu-Wlm3; Making A Wi-Fi Connection - Sony PMW-200 Operating Instructions Manual

Depending on the microphone used, a humming/
buzzing noise may be recorded. In this case,
inserting the cable of the external microphone
into the cable clamp (page 44), which is located
under the AUDIO IN CH-1/CH-2 connectors,
should solve the problem.

Connecting the IFU-WLM3

Open the cover of the external device connector,
then connect the IFU-WLM3.
Notes
• The IFU-WLM3 USB Wireless LAN Module (sold
separately) may not be available in some countries/
regions.
• Attach/remove the IFU-WLM3 after the camcorder is
turned off.
• If you use a wireless device near the camcorder, the
camcorder may not work correctly. Turn the wireless
device off near the camcorder.

Making a Wi-Fi Connection

Two types of Wi-Fi connections are available. In
"ad-hoc mode", you can make a peer-to-peer Wi-
Fi connection between a computer and
camcorder. In "infrastructure mode", you can
make Wi-Fi connections between a computer and
multiple camcorders via a wireless LAN access
point (building a LAN).
To make a network setting
Change settings under OTHERS >Network in the
setup menu as required.
Item Setting
DHCP Setting that specifies whether to
acquire the IP address automatically
from a DHCP server
Enabled: Acquire automatically.
Disabled: Do not acquire
automatically (factory default setting).
IP Address a)
IP address
192.168.1.10)
Subnet Mask Subnet mask (factory default setting:
255.255.255.0)
Default Default gateway (factory default
Gateway setting: 0.0.0.0)
User Name User name for log-in (factory default
setting: admin)
Password Password for log-in (factory default
setting: model name "pmw-200")
(factory default setting:
a) The IP address determined by DHCP server is
displayed here.
When you have changed a setting
Set the Set item to [Execute]. When a
confirmation message appears, use the up/down/
left/right buttons or the jog dial to select
"Execute" and press the SEL/SET button or the
jog dial.
To make a connection in ad hoc mode
1
Make the connection settings on the
computer.
2
Start a connection on the computer.
3
Set OTHERS >Wi-Fi >Wi-Fi to
[Enable] in the setup menu.
4
Set OTHERS >Wi-Fi >Scan Networks
to [Execute] and press the SEL/SET
button or the jog dial.
The camcorder starts scanning for a network
connection.
When networks are detected, the
NETWORK SCAN list appears.
Note
When using the IFU-WLM3 USB Wireless LAN
Module, "Unknown" appears for the detection
result. In this case, set "Network Type" to "Infra" or
"Adhoc."
5
Turn the up/down/left/right buttons or
the jog dial to select a network and press
the SEL/SET button or the jog dial.
The OTHERS menu appears again.
6
Confirm that the settings for the Wi-Fi
item conform to the network setting on
the computer.
SSID (network name): Selected network
name
Network Type (connection mode): Adhoc
CH (channel): 1
Authentication (network authentication):
Depending the settings on the computer,
Open, Shared or WPA
Encryption (data encryption): Depending
the settings on the computer, Disable, WEP,
TKIP or AES
WEP Key Index (key index): 1 when
Encryption is set to [WEP]
Using Wi-Fi Connection (PMW-200 only) 31