Motorola AP-5181 Deployment Manual page 9

Hide thumbs Also See for AP-5181:

Deployment Guide

6. Position and hold the tilt bracket and each of the band clamps onto the mounting pole. Thread the band

clamp through its own adjuster screw. Ensure the band clamp is installed into it's own adjust screw.

Thread the free end of the band clamp through the adjuster. Pass through the screw, and pull the free end

of the clamp until it is snug. Repeat this process for the second clamp.

Point the tilt bracket in the direction the AP-5181 is to be mounted. Tighten the band clamps. Cut-off or

wrap around (as displayed above) the free end of the tightened band clamp.

7. Install the AP-5181's mounting bracket onto the tilt bracket. Use one long binder head screw and hex nut

from the kit. This will provide the pivot about which the AP-5181 can be tilted. Do not over tighten the nut.