6.2.2.2 Cables connection
Connection the cables according to the definition, and weld the cable joint to keep it
fastness, and use the pyrocondensation tube to packing it well.
Take care below points:
1) The power supply cable must connect correct, red cable to positive, black cable to
negative, can't be in reverse.
2) Fingerprint reader Wiegand output signal cables, connect the Wiegand of the controller
for transferring fingerprint ID to controller;
3) Power supply cables suggest to use more than 0.5 square mm, signal cables use
AWG16#-AWG24# cables, much better to use shielded wire pipe to make the cables low
down the possibility of the outside interferences.
7. Packing List
Item
1
Fingerprint Reader
2
8P BNC multi color cables
3
M4*12mm flat crews
4
M6*30 rubber plug
5
6
Fingerprin
t Reader
Content
User Manual
Certification
CHD200G series Fingerprint Reader
Metal board
Qty
1pcs
1pcs
2pcs
2pcs
1pcs
1pcs
8
Remark