Table of Contents
Advertisement
Lighting of Oven Burner
IMPORTANT: The oven door must be open during this operation.
To ignite the oven burner:
1
Fully open the oven door.
If this operation is not performed you should not proceed to light the oven.
2.
Press the thermostat knob throughly to start up the electric ignition and, keeping the knob under pres-
sure turn it anti-clockwise (fig. 4) to the maximum position
Never continue this operation for more than 15 seconds. If the burner has still not ignited, wait for
about 1 minute prior to repeating the ignition.
In case of mains failure, to light the oven manually, approach a flame to the hole "A" of the floor (fig. 5),
then press and turn the thermostat knob (fig. 4).
3.
Wait about ten seconds after lighting the burner to release the knob (priming time of the thermocouple).
4.
Check that the burner has lit; if not, turn the knob clockwise back to " " (OFF) and repeat the procedure
from step 1.
5.
Close the oven door slowly and adjust the thermostat knob on the desired setting.
If the flame extinguishes for any reason, the safety valve will automatically shut off the gas supply to the burner.
To re-light the burner, first turn the oven control knob to OFF position (" "), wait for at least 1 minute and
then repeat the lighting procedure.
For the correct use of the gas oven see the chapters "COOKING WITH GAS OVEN" and "COOKING WITH FAN
ASSISTED GAS OVEN".
During and after use of the oven, certain parts will become very hot.
Keep children away.
ATTENTION: In case of manual lighting, never turn the thermostat before approaching a flame to the
hole "A" of the floor.
Fig. 4
(fig. 3).
240
A
Fig. 5
9
Advertisement
Table of Contents
