Replacing The Oven Lamp - CDA sg120 Series Manual For Installation, Use And Maintenance

Replacing the Oven Lamp

WARNING: Ensure the appliance is switched off before replacing the
lamp to avoid the possibility of electric shock.
− Let the oven cavity and the heating elements to
cool down.
− Switch off the electrical supply.
− Remove the protective cover "A" (fig. 13).
− Unscrew and replace the bulb "B" with a new one
suitable for high temperatures (300°C) having the
following specifications: 230V or 220-240V, E14 and
same power (check watt power as stamped in the
bulb itself ) of the replaced bulb.
− Refit the protective cover "A".
Note: Oven bulb replacement is not covered by your
guarantee.
Assembling and Dismantling of the Side Runner Frames
− Fit the side runner frames into the holes on the side walls inside the oven (fig. 14).
− Slide the drip pan and rack into the runners as shown in fig. 15.


The rack must be fitted so that the safety catch, which stops it sliding out, faces the inside of the oven.
− To dismantle, operate in reverse order.
16
Fig. 14
B
A
Fig. 13
Fig. 15