Table of Contents
Advertisement
Operations to Be Executed for the Replacement of the Injectors of the Oven and
Grill Burners
Some models are provided with a set of injectors for the various types of gas.
If the injectors are not supplied they can be obtained from the "Service Centre".
Select the injectors to be replaced according to the "Table for the choice of the injectors".
The nozzle diameters, expressed in hundredths of a millimetre, are marked on the body of each injector.
Oven Burner
−
Lift and remove the lower panel inside the oven.
−
Unscrew and remove the burner securing screw "A" (fig. 40).
−
Withdraw the burner as shown in figure 41 and rest it inside the oven. Take care not to damage the safety
valve probe and the electric ignition electrode.
−
Using a 7 mm box spanner, unscrew the injector (indicated by the arrow in fig. 41) and replace it with a
new one selected in accordance with the "Table for the choice of the injectors".
−
Regulate the air supply to the oven burner as indicated in the section "Regulation of air supply to oven
and grill burners"; then replace the
burner and the other components
repeating the above steps in reverse
order.
IMPORTANT: Check the correct
operation of the safety valve and
the ignition electrode.
30
Fig. 40
Fig. 41
A
Advertisement
Table of Contents
