Phonetics SENSAPHONE 1100 Owner's Manual page 34

®
Sensaphone Model 1100 Instruction Manual
It will stop the dialout sequence for this alarm.
The status report feature allows you to call in to the Model 1100 and
check the temperature, alarm and power status. The unit will answer after
the programmed rings until answer (see Chapter 3, page 19). If any
alarm conditions exist, the alarm message will be recited. You can also
listen in to on-site sounds.
The following is an example of what the unit will recite during a status
report:
Hello
This is telephone number 555-1234 (User-programmed unit phone
number)
The time is 12:15 PM (Current time)
Alert condition OK (Alarm status. Other responses: 1 EXISTS, 2
EXISTS, 3 EXISTS, 4 EXISTS)
The temperature is 70 degrees (Current temperature)
OK (Temperature alarm condition. Other responses: The temperature is
high! low.)
Two. (Says this only if a remote temperature sensor is attached to the
AUX input.)
The temperature is 70 degrees (Says this only if a remote temperature
sensor is attached to the AUX input.)
The electricity is ON (Power status. Other response: OFF)
Battery condition OK (Backup battery condition. Other response:
Battery condition low. Replace batteries.)
Sound level OK (Sound level status. Other response: HIGH)
NO NUMBER (Says this only if no dialout phone numbers have been
programmed.)
Listen to the sound level for 10 seconds (User-programmed listen-in
time) Have a good day.
The Model 1100 repeats the status report once more and then hangs up.
32