Listen-In Time - Phonetics SENSAPHONE 1100 Owner's Manual

®
Sensaphone Model 1100 Instruction Manual
2. Press the SENSOR ON/OFF key
3. Press the TAD key
The 1100 will say "On." (If the 1100 says "Off," repeat steps 2 and 3.)
4. Using the above example, when you call in, let the phone ring twice
and then hang up. The 1100 recognizes that a call was made and
activates a 3-minute internal timer. This allows you 3 minutes to call back
and get the unit instead of the answering machine.
5. Call back within 3 minutes. The 1100 will override the answering device
on the callback and answer the phone on the first ring.
SENSOR
0
ON/OFF
NOTE: When you are using TAD and acknowledging an alarm by
calling back, the Sensaphone will answer on the first ring. See
Chapter 5, page 33.
To interrogate rings until answer and TAD:
1. Press the WHAT IS key
2. Press the RINGS/TAD key
If TAD is enabled, the 1100 will simply recite the rings until answer value.
(Above example: 'Five.') If TAD is disabled, the 1100 will say "Off" and
then recite the rings until answer value. (Above example: "Off. Five.')
WHAT
0
IS

LISTEN-IN TIME

The listen-in time is the amount of time you can listen to sounds at the
unit site during a status call in. The programmable range is 1 to 199
seconds. The default value is 10 seconds. NOTE: The microphone is also
used to monitor high sound level. See Chapter 4, page 30.
To program the listen-in time:
1. Press the SET key
2. Press the LISTEN TIME key
3. Using the number keys, enter the seconds
The 1100 will recite the numbers as you press them.
4. Press ENTER
The 1100 will say "Enter."
18
RINGS
TAD
RINGS
TAD