The Unit Id Number - Phonetics SENSAPHONE 1100 Owner's Manual

®
Sensaphone Model 1100 Instruction Manual
3. Using the number keys, enter the digits of the programmed code
The 1100 will recite the digits as they are pressed.
4. Press ENTER
If the correct code is entered, the 1100 will say "ok." If the wrong code is
entered, the 1100 will say "Error two."
UNLOCK
NOTE: If you forget your security code, take the batteries out first
and then unplug the AC transformer. Next, plug the AC trans-
former back into the outlet and reinstall the batteries. This resets
all parameters so you will have to reprogram.

THE UNIT ID NUMBER

The Model 1100 unit ID number can be up to 16 digits long. It is usually
the telephone number where the unit is installed. The ID should be
programmed AFTER all the sensors are wired to the unit in their normal
state (See Chapter 2, pages 9-10). Programming the ID number estab-
lishes the normal condition of the alert input in the Model 1100's memory.
To program the ID number:
1. Press the SET key
2. Press the ID# key
3. Using the number keys, enter up to 16 digits for the ID number
The 1100 will recite the digits as they are pressed.
4. Press ENTER
The 1100 will say "Enter."
9
SET
To interrogate:
1. Press the WHAT IS key
2. Press the ID# key
The 1100 will say "This is telephone number," then recite the ID number
and provide a status report. (See Chapter 5, page 34 for more informa-
tion on the status report.)
20
KEY
(enter security code)
STATUS
ID#
(enter number)
ENTER
PM
ENTER
PM