Tone Or Pulse Dialing; Special Dialing - Phonetics SENSAPHONE 1100 Owner's Manual

NOTE: This command also indicates whether the input (1-4) s
enabled or disabled. If the 1100 says 'Off" before reciting the
phone number, it means that the input has been disabled. See
Chapter 4.
To erase a Phone number:
1. Press the SET key
2. Press the number key (1-4) of the Phone number you want to erase
3. Press ENTER. The 1100 will say "Enter."
1
SET

TONE OR PULSE DIALING

The Sensaphone will normally dial out to a Phone number using pulse.
However, you can switch to Touch-ToneTM by inserting TONE as the first
digit of the Phone number.
To set a TONE-dialed Phone number:
1. Press the SET key
2. Press the number key (1-4) of the Phone number you want to set
3. Press the TONE key
The 1100 will beep.
4. Enter the digits of the Phone number using the number keys
The 1100 will recite the digits as you press them.
5. Press ENTER. The 1100 will say "Enter."
1
SET
When you interrogate, the tone will be represented by a beep at the
beginning of the Phone number.
NOTE: TONE is counted as one digit toward the total 16 digits
allowed.

SPECIAL DIALING

The Model 1100 has provisions for special dialing sequences. There are
three keys that represent special functions when used within a Phone
number. The PAUSE key represents a 4-second pause in dialing. It is
used mainly when you must first dial an access number, such as 9, to
reach an outside line. The SET key represents the pound (#) tone and
ENTER
PM
PAUSE
TONE
MUTE
AM
(phone number)
ENTER
PM
15