Cleaning
Cleaning the autocutter
If adhesive from the label paper adheres to the autocutter, the autocutter may become blunt.
In this case, clean the autocutter with the following steps.
1
Turn the printer power off, and disconnect the AC cable from the wall out-
let.
2
Open the roll paper cover and remove the paper.
See
"How to eject paper for paper replacement" on page 56
3
Remove the adhesive on the autocutter fixed blade of the roll paper cover
side with a cotton swab. Slightly moisten the cotton swab with alcohol, if
necessary.
Do not touch the autocutter fixed blade directly with fingers during cleaning, or injury may
result.
WARNING
Chapter 3
Handling
141
3