Setting The Dip Switches; Setting Procedure - Epson TM-C7500 Series Technical Reference Manual

Setting the Dip Switches

Follow the steps below to change the Dip switch settings.

Setting Procedure

Follow the steps below to change the Dip switch settings.
Before you remove the DIP switch cover, turn the product off. Otherwise, a short-circuit may
cause the product to malfunction.
CAUTION
DIP switch settings are enabled only when the power is turned on. If the settings are changed
after that, the functions will not change.
1
Make sure the power supply for the product is turned off.
2
Remove the Dip switch cover mounting screw from the rear side of the
product and open the Dip switch cover.
3
Set the DIP switches, using the tip of a tool, such as a tweezers.
4
Replace the DIP switch cover, and screw it in place.
Functions
SW
1
2
3
4
 Do not change Dip switch 2 to 4.
 An SDHC memory card is located below the dip switches. Do not remove it, replace it or do
CAUTION
140
ON
Power button: Disabled
(Reset operation)
Forbidden (Do not change setting)
Reserved (Do not change setting)
Reserved (Do not change setting)
anything else to it. This card is used for internal processing.
Dip Switch Cover
Dip Switch
Dip Switch Cover mounting screw
OFF
Power button: Enabled
(Power ON/OFF operation)
Initial setting
OFF
OFF
OFF
OFF