Arming And Disarming The System; Arming The System; Arming In Away Mode - Bosch AMAX 2100 User Manual

14 en | Arming and Disarming the System
3

Arming and Disarming the System

3.1

Arming the System

Notice!
When the number of incorrect code entries on the keypad reaches a specified limit
(configured by the installer), the keypad will automatically lock for 180 seconds and an alarm
is reported. If the keypad is idle for one minute, the system will automatically exit from any
operational mode.
3.1.1

Arming in AWAY Mode

The AWAY Mode is used to arm the premises to detect a would-be intruder, when you leave
the premises and require that all zones are activated in a ready state.
Keypad Arming
There are two methods to arm your system in AWAY mode.
Method 1:
4
P
Method 2 (Quick Arm):
4
P
Please contact your installer to enable/disable this function.
Telephone Remote Arming
Users can use a telephone to arm the system.
1.
2.
P
Please contact your installer to enable/disable this function.
Notice!
Telephone remote arming is only possible when the system has only one assigned area.
Key Switch Arming
Users can use a key switch to arm the system.
4
P
Please contact your installer to enable/disable this function.
2014.09 | 03 | F.01U.295.569
Enter your code and press [#].
The system beeps twice, the AWAY indicator flashes slowly and exit time starts. After the
exit time, the AWAY indicator is lit.
Press and hold [#] until the system beeps twice.
The AWAY indicator flashes slowly and exit time starts. After the exit time, the AWAY
indicator is lit.
Dial the control panel number.
The control panel answers the call and issues a long beep.
Press [#].
When the panel receives the signal it confirms the arming of the control panel with a high
tone.
Activate the key switch.
The AWAY indicator flashes slowly and exit time starts. After exit time, the AWAY indicator
is lit.
User Guide
AMAX
Bosch Sicherheitsysteme GmbH