Connecting Sata Devices (Optional); Connecting Usb Devices (Optional) - Medion X50 Operating Instructions Manual

5.4.

Connecting SATA devices (optional)

eSATA stands for "external Serial ATA" and is a connection for external hard drives. Compared with the conventional USB
standard, the transfer speed with an eSATA connection is higher than with external USB hard drives.
PLEASE NOTE!
In order to prevent damage to the contacts, make sure that the plug and the socket fit together perfectly. Due to its
asymmetric form, the plug will only fit into the socket in one position.
 Plug the cable into the eSATA socket on the front of your PC.
5.4.1. Disconnecting SATA Devices
 Before disconnecting a SATA hard drive from your PC, click the Safely remove hardware icon in the task bar below and
then click on the hard drive to be removed.
5.5.

Connecting USB devices (optional)

ATTENTION!
Do not connect your USB devices until you have finished the initial setup of your new PC. This will prevent any unneces-
sary interference during the installation. These devices can generally be connected while the PC is running. Please refer to
the operating manual for your peripheral device.
• The PC's USB voltage outputs are protected by a fuse (limited power source in accordance with EN60950). This ensures that
peripheral devices connected using the sockets in question cannot be damaged in the event of a technical fault with the
PC.
You will usually have several connection sockets available that you can use as desired.
PLEASE NOTE!
In order to prevent damage to the contacts, make sure that the plug and the socket fit together perfectly. Due to its
asymmetric form, the plug will only fit into the socket in one position.
 Plug the device (printer, scanner, camera, etc.) into the appropriate socket.
PLEASE NOTE!
Where possible, always connect your devices to the same port that they were originally installed on. Otherwise they will
be assigned a new ID and the drivers will need to be reinstalled.
9 of 36