Uploading The Default Configuration File Via Boot Commands; Figure 9 Example Xmodem Upload - ZyXEL Communications ALC1248G User Manual

Chapter 3 Troubleshooting
The MSC resets the line card after a period of inactivity on the line card. This
may damage the line card if you are uploading the default configuration file or
new firmware to the line card. Use the
the MSC to prevent the MSC from managing the line card.
After you upload the file successfully, use the
on the MSC to allow the MSC to manage the line card again. Refer to the MSC
User's Guide for details about commands.

3.5.1 Uploading the Default Configuration File via Boot Commands

Obtain the default configuration file, unzip it and save it in a folder. Use a console cable to
connect a computer with terminal emulation software to the line card's console port. Pull out
the line card and push it back in, you will see the initial screen. When you see the message
Press any key to enter Debug Mode within 3 seconds
debug mode.
To upload the configuration file, do the following:
1 Type atlc after the Enter Debug Mode message.
2 Wait for the Starting XMODEM upload message before activating XMODEM
upload on your terminal.
3 This is an example Xmodem configuration upload using HyperTerminal. Click
Transfer, then Send File to display the following screen.

Figure 9 Example Xmodem Upload

32
lcman disable <slot>
lcman enable <slot>
press any key to enter
Type the configuration file's
location, or click Browse to
search for it.
Choose the 1K Xmodem
protocol.
Then click Send.
ALC1248G User's Guide
command on
command