Table of Contents
Advertisement
Prepare the dispenser.
2.1
3.1
Bin Signal Installation
• Mount the electrical box to the side of the Vision dispenser
connection.
Note: If a 4 x 4 box is mounted to a non-grounded surface, connect ground wire at an
appropriate ground.
• Connect the bin signal plug on the electrical box to the bin signal cord on the bin
• Insert 24" (609,6mm) of the long bin signal cable
docking station
• After sliding the icemaker module into the louvered docking station, disconnect the shuttle
➎
plug
from the icemaker control box.
• Complete normal installation procedure for the icemaker using the installation manual that
shipped with the icemaker.
• Connect the bin signal plug
6
➏
➎
➏
24"
(610 mm)
➌
➍
and secure in place with strain relief provided.
➏
into the icemaker control box.
Dispenser preparation
➍
➊
to establish a ground
➌
into the hole in the back of the louvered
remote condensing
➋
➌
➋
VISION • SATELLITE-FILL
3
Ground
➊
Advertisement
Table of Contents
