Dispenser Preparation - Follett Horizon Elite HCD1010RVS Installation Instructions Manual

Prepare the dispenser.
2.1 3.1
Bin Signal Installation
• Mount the electrical box to the side of the Vision dispenser
Note: If a 4 x 4 box is mounted to a non-grounded surface, connect ground wire at an
appropriate ground.
• Connect the bin signal plug on the electrical box to the bin signal cord on the bin
• Insert 24" (70 cm) of the long bin signal cable
➍
and secure in place with strain relief provided.
• After sliding the ice machine module into the docking station, disconnect one wire from shuttle
switch and replace with wire from adapter plug.
• Connect wire removed from shuttle switch to male connector on adapter plug wire.
• Complete normal installation procedure for the ice machine using the installation manual that
shipped with the ice machine.
• Connect adapter plug into bin signal plug.
6
➎
➌ 24"
(610 mm)
➌
into the hole in the back of the docking station
➎
➐
remote condensing

Dispenser preparation

➏
➐
➍
➊ to establish a ground connection.
VISION • RIDE Technology
3
➋
Ground
➊
➋
➏