COMMISSIONING
5.6
FINISHING COMMISSIONING
The boiler has been factory set, so there should be no
need to adjust combustion settings.
REPLACE OUTER CASING:
1. Replace outer casing making sure that the securing points are
properly located.
B Press the clip (A) downwards to secure casing on top.
B Retighten bottom two screws (B).
A
Fig. 43 Fitting outer case
INSTALLING BOTTOM PANEL:
2. The bottom panel slides onto two ledges (C) either side of the boiler
frame.
B Hold the panel up against the underside of the boiler and slide
towards the rear until it is fully engaged.
HANDOVER:
B Complete the Benchmark check list.
B The fascia cover is opened by pulling the flap (D) towards you.
B Set up the controls and show the user how to operate all the controls
shown in the User Guide.
B If the appliance is unused and exposed to freezing conditions; shut off
all the mains supplies and drain the system and boiler.
34
B
B
6720647361-25.3Wo
D
Fig. 44 Fitting bottom panel
C
6720647361-26.3Wo
6 720 803 599 (2012/06)