Assembly - Pride Mobility Jet 7 Owner's Manual

Assemble the front frame and power base frame assemblies.
1. Place the three frame assemblies next to each other as shown in
figure 22.
2. Grasp the front frame and fit the bottom bar notch onto the locat-
ing pin on the lower section of the power base frame assembly.
See figure 23.
3. Pivot the front frame top bar toward the power base frame
assembly and push the front frame top bar onto the locking mecha-
nism until the two assemblies snap securely into place. See figure 22.
4. Repeat for the other power base frame assembly.
CAUTION! Make certain that the front frame is snapped
securely to both the right frame assembly and to the
left frame assembly.
Install the battery well frame.
1. Hold the battery well frame so that the bottom of the well hangs
downward.
2. Position the notches on the front of the battery well frame onto the
locating pins on the front frame bottom bar. See figure 25.
3. Fit the notch on either side of the battery well frame rear onto the
locating pin on the power base frame assembly and onto the lo-
cating pin on the other power base frame assembly.
4. Make certain that the locking mechanisms snap securely into place.
Install the battery boxes.
1. Place the front battery box into the the battery well frame front end.
NOTE: Make certain that the battery box connectors are
facing each other.
2. Place the rear battery box into the battery well frame back end.
Make certain that none of the wiring harnesses or cables are
pinched between the battery or the electronics tray and the frame.
3. Connect the battery boxes. Use the battery connection label lo-
cated on the battery box for a reference.
4. Reconnect the left and right motor connectors. Be certain to match
the left connector to the left motor and the right connector to the
right motor. The connectors are labeled left and right.
Install the seat.
1. Pick up the seat by the frame and slide the locating pins near the
back of the frame into the matching slots on the left and rear seat
post mounts.
2. Slide the pins to the back of the slots. It may be necessary to
wiggle the seat slightly from side to side to seat the pins firmly at
the back of the slots.
3. Push the front of the seat frame down until both the left and the
right frame sides lock into the front seat post mounts.
Install the footrest.
1. Match the two tabs at the back of the footrest with the two semicir-
cular notches in the vertical bar of the front frame.
2. Push the tabs through the matching notches.
3. Slide the footrest down into place.
Connect the controller.
Reconnect the controller and charger harnesses. See figure 4.
CAUTION! Do not place the controller cable so that it can be pinched in the seat frame or the power base
frame.
JET7/REV A/OCTOBER 2002
Figure 22. Frame Assemblies
Figure 23. Connecting Front Frame Assembly
Figure 24. Fitting the Frames
Figure 25. Connecting Battery Well Frame
WWW.PRIDEMOBILITY.COM

Assembly

19