Pride Mobility Jet 7 Owner's Manual page 18

Power chair
Hide thumbs Also See for Jet 7:
Table of Contents

Advertisement

WARNING! Do not pick up the seat frame by the
armrests. They are free to pivot, and you may
lose control of the seat if they do so, resulting in
personal injury and/or damage to the chair.
Remove the footrest.
Slide the footrest up until the tabs on the footrest can be pulled
forward through the matching slots in the front frame. See
figure 18.
Remove the battery well frame.
1. Disconnect both battery box and motor connectors. See
figure 2.
2. Lift and remove each battery box. See figure 19.
3. Squeeze together the latch release levers that hang
vertically down from the crossbar at the battery well frame
rear. See figure 20. Lift up the battery well frame rear. Pull it
to the rear of the chair to release the front slots from the
locating pins on the front frame bottom bar. See figure 21.
Disassemble the Right/Left Frame Assembly from the Front
Frame.
1. Choose which side of the frame assembly (right/left) you
want to disassemble first.
2. After making your determination, stand behind the Jet and
grasp the frame assembly handle on the side you wish
to disassemble first (located next to the front seat post tower).
See figure 21.
3. Use your hand and thumb to hold the front frame and press
and hold (toward the center of the front
frame) the silver-coloured latch release lever. See figure 21.
4. Hold the frame assembly with one hand and push the frame
assembly outward.
5. Pull up on the front frame with your other hand until the
latching mechanism releases.
6. Keep pulling upward with your hand until the locating pin on
the bottom of that side of the front frame releases from its
slot in the frame assembly.
7. Carefully let the frame assembly tilt to a resting position.
SQUEEZE LATCH
RELEASE LEVERS
Figure 20. Removing Battery Well
18
WWW.PRIDEMOBILITY.COM
SEAT RELEASE PLUNGERS
Figure 17. Removing the Seat
SLIDE FOOTREST UP AND PULL
FORWARD TO REMOVE
Figure 18. Removing the Footrest
Figure 19. Removing Battery Boxes
FRONT FRAME
LOCATING PINS
Figure 21. Removing Front Frame
JET7/REV A/OCTOBER 2002

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents