Set Up A Web Filter To Be A Target Server - M86 Security M86 Web Filter User Manual

Hide thumbs Also See for M86 Web Filter:

Table of Contents

NOTE: See the Backup/Restore window for information on

restoring data to a server.

Set up a Web Filter to be a Target Server

A Web Filter configured to be a target server will receive

profile/library setting changes from the source server only.

WARNING: If a Web Filter server is set up in the Target mode

with a NAT device between the target and source server, be sure

that ports 26262 and 26268 are open on the target server. This

setup is required so that the target server can communicate with

the source server.

For the Target mode setting:

1. In the Mode frame, click "Target" to display the Target

2. In the Source IP frame, enter the Source IP address to

Fig. 2:1-45 Setup window, Target mode

In the IP to Send frame, the LAN1 and LAN2 IP

addresses set up in the LAN Settings window on this

server display in the IP to Send pull-down menu.

use for sending profile/library setting changes to this

server being configured.

DMINISTRATOR

YSTEM SCREEN