How To Use The Thermal Sensor; Iwill Scsi Series - IWILL VD133 Operation Manual

4. Select "Boot Sequence" and change the default setting from A, C, SCSI to "CD-
ROM, C, A" using Page Up /Page Down key.
5. Place the Windows NT 4.0 CD-ROM in the drive.
6. Follow all instructions to finish Windows NT installation.

5.4 How to use the Thermal sensor

5.5 IWILL SCSI series

If you want to improve I/O performance of your VD133, choose the latest IWILL SCSI controllers.
The following are some IWILL SCSI controllers you may purchase, and use with your VD133
motherboard:
SIDE 2930C:
an economical SCSI card, and connects up to 7 devices
Detects all heat-releasing devices. Firmly screw the
connector to any device.
- Supports SCSI-1, SCSI-2 protocol
- 10 MB/sec. data transfer rate
- The best choice for CD-ROM, CD-R, CD-R/W,
MO, Scanner ... etc.
- Connects maximum 7 narrow SCSI devices
- Automatic active termination control for easy
plug & play installation.
63