Table of Contents
Advertisement
Turning Power On or Off
1.
Press Button 1 (P) to turn on
power.
2.
To turn off power, press Button 1
again.
NOTE
• Turning off power puts TRACKFORMER into a
standby state. Minute amounts of current continue
to flow within TRACKFORMER in the standby state.
If you do not plan to use the product for a long time
or if there is a chance of a lightning storm in your
area, be sure to unplug the AC adaptor from the
power outlet.
Auto Power Off
TRACKFORMER turns off automatically to avoid
wasting power if no operation is performed for a preset
amount of time. Auto Power Off trigger times are
shown below.
Battery-powered operation
Approximately 30 minutes
AC adaptor-powered operation
Approximately four hours
USB bus-powered operation
Approximately four hours
NOTE
• If you want to produce continual sound over a
longer period, you can cancel Auto Power Off by
holding down the [A] button while you press the P
(Power) button to turn on TRACKFORMER.
P button
1
A button
Charging an iOS Device,
Built-in Speaker Operation
IMPORTANT!
• TRACKFORMER supports operation using one of
three different power supplies. Note, however, that
the amount of power provided depends on the type
of power supply being used, so built-in speaker
operation is not supported in some cases. The
following table shows details for each power supply
method.
AC Adaptor
TRACK-
Supported
FORMER
built-in
speaker
operation
IMPORTANT!
• Connect the AC adaptor to TRACKFORMER if you
plan to charge an iOS device.
• Note that charging of an iOS device is not supported
while TRACKFORMER is running under USB bus
power or battery power.
• Charging of an iPad is not supported.
NOTE
• If multiple power supply methods are available,
TRACKFORMER will select a power supply
according to the following priority: AC adaptor 3
Batteries 3 USB Bus power.
Power Requirements
Batteries
USB Bus Power
Supported
Not supported
EN-13
Hide quick links:
Advertisement
Table of Contents
