Assembling The Mounting Hardware - Cisco AIR-LAP1310G Mounting Instructions

Mounting the Access Point
Visually inspect the seal to make sure the entire connector area is completely covered. If you find gaps,
Step 5
apply additional Coax-Seal over the existing material and then mold it to shape.
Step 6 Repeat this procedure for each coaxial connection on the access point and grounding blocks.

Assembling the Mounting Hardware

The access point mounting hardware can accommodate tower, mast, or rooftop installations. The
mounting hardware comprises the following key parts:
•
•
•
Assembling the Rooftop Mount
The rooftop mount or wall mounting bracket (see
horizontal or vertical surface, such as a building roof or wall. You must assemble the rooftop mount
before you can use it. Skip this section if you are not using the rooftop mount.
To assemble the mount, follow the instructions below:
Place a washer on the long flanged hex bolt.
Step 1
Place the end of the mast pipe with the bolt holes into the base plate (see
Step 2
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
26
Housing brackets
Mounting bracket
Rooftop mount or wall mounting bracket
Figure 9) is used to mount your access point to a flat
Figure 9).
78-17634-01