Cisco AIR-LAP1310G Mounting Instructions page 16

Mounting the Access Point
Mounting the Access Point
To mount the access point on a rooftop or wall, follow these steps:
Step 1 Choose a mounting location for the access point. If you are using the integrated antenna, the mounting
location must provide a clear signal path to the remote access point. For more information, see
"Choosing a Mounting Location" section on page
Step 2 Find a solid mounting position for the base bracket, such as a stud or main building member on a roof
or external wall. It may be necessary to utilize a stud finder to find wooden structural members.
Assemble the rooftop mount. For more information, see the
Step 3
on page
Mount the rooftop bracket at the mounting location using the following user-provided hardware:
Step 4
•
•
Figure 4
Figure 4
Make sure that the mounting pole is vertical. You can rotate the foot of the bracket to adjust the vertical
position for wall or sloped-roof mounting locations.
Step 5 Tighten the bolts to secure the mounting pole to the mounting foot. Torque nuts to 12 to 14 ft-lb.
Step 6 Attach the access point to the vertical section of the pole using the supplied brackets and hardware. For
more information, see the
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
16
26.
Wooden structure—four 1/4 x 2 inch (minimum) lag bolts
Concrete structure—four 1/4 x 1 inch (minimum) bolts with concrete anchors
shows the rooftop mast assembly:
Roof-Mount Mast
"Assembling the Mounting Hardware" section on page
7.
"Assembling the Rooftop Mount" section
26.
78-17634-01