Required Tools And Fasteners - Cisco AIR-LAP1310G Mounting Instructions

Required Tools and Fasteners

This section describes the required tools, cables, and fasteners.
Tools
Mounting the access point requires the following tools:
•
•
•
•
You may also require tools for user-supplied hardware or fasteners.
Cables
Cisco recommends the following types of coaxial cable for the access point-to-power injector
connections:
Table 1
Cable Type
RG6
RG59/U
RG59/U
RG11/U
Fasteners
Identify requirements for special hardware or fasteners that are not supplied in the installation kit. For
example, it might be necessary to secure the access point to an unusually large-diameter pipe or
odd-shaped structural member that the supplied mounting bracket cannot accommodate.
The rooftop or wall mounting bracket requires the following user-provided fasteners:
•
•
•
The wall or ceiling mounting bracket requires the following user-provided fasteners:
•
•
•
For the user-provided fasteners, you must use the appropriate drill size recommended by your fastener
Note
vendor.
78-17634-01
7-mm, 8-mm, and 13-mm wrench or socket for mult-function mount
Two 7/16 wrenches or sockets for roof mount
Crimping tool for F-connectors that accommodates RG6/U cable (http://www.tessco.com)
Crimping tool for ground lug, Panduit CT-1004 or equivalent (http://onlinecatalog.panduit.com)
Recommended Coaxial Cable Types
Belden Part #
9077
1426A
1505A
8213
Wooden structure—four 1/4 x 1 inch (minimum) lag bolts
Hollow walls—four 1/4-20 x 2 3/4 molly anchors
Concrete structure—four 1/4 x 1 3/4 inch (minimum) bolts with concrete anchors
Wooden structure—three 1/4 x 1 inch (minimum) lag bolts
Hollow walls—three 1/4-20 x 2 3/4 molly anchors
Concrete structure—three 1/4 x 1 3/4 inch (minimum) bolts with concrete anchors
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
Times Fiber Part # Channel Master Part #
2360-T660-VB or 9539
2560-T690-VB
02345-T5953-VB 9540
02183-T5967-VB –
02362-T1153-VB –
Mounting the Access Point
11