Auxiliary Function Selection; Starting The Programme; Child Lock; Progress Of Programme - Smeg SW85 Manual

Table of Contents

Advertisement

Auxiliary function selection

starting the programme. Furthermore, you can also
to the running programme without pressing the
or cancel.
canceled, light of the relevant auxiliary function will
C
canceled and the second auxiliary function
selection will remain active.
C
C
to the model of the machine.
A Prewash is only worthwhile for heavily soiled
laundry. Not using the Prewash will save energy,
water, detergent and time.
C
As their meshed texture causes excessive
amount of detergent into the main wash
prewash compartment.
another rinsing in addition to the one already made
after the main wash. Thus, the risk for sensitive
the minimal detergent remnants on the laundry can
immediately after the programme completes, you
can use rinse hold function to keep your laundry
in the final rinsing water in order to prevent them
from getting wrinkled when there is no water in the
machine.
laundry held in water.
if you want to spin your laundry held in water.
C
pump step is completed and the water in the
machine is drained. Thus, water inside the
machine is drained and your laundry is not
spun.
in cold water.
This function allows spinning of laundry at a
speed lower than the maximum spin speed of the
machine.
specified on the control panel.

Starting the programme

up to indicate that the programme has started.
turns off.

Child Lock

tampering with the machine. Thus you can avoid
any changes in a running programme.
C
You can switch on and off the machine with
When you switch on the machine again,
programme will resume from where it has
To activate the Child Lock:
Press and hold 1
washing programme has started. The 1
Function light flashes continuously.
To deactivate the Child Lock:
programme after the programme has finished or to
interrupt a running program.
Press and hold 1
child lock.

Progress of programme

relevant indicator light will turn on and light of the
completed step will turn off.
To change the auxiliary function, speed and
temperature settings while a program is running,
you need to switch the machine to Pause mode.
Pause / Cancel light flashes.
C
machine.
12
EN
st
nd
and 2
Auxiliary Function
st
nd
and 2
Auxiliary Function
st
Auxiliary

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sw65

Table of Contents