Bayer HealthCare Contour next User Manual page 10

12 ®
3. Insert the lancet firmly
into the lancing device
until it comes to a full
stop. This will re-set the
device. You can also
pull and release the
re-setting handle.
4. Twist off the round
protective lancet cap.
Save it for disposing of
the used lancet.
5. Replace the gray
endcap.
6. Rotate the endcap dial
to adjust the puncture
depth. The amount of
pressure applied to the
puncture site also affects
puncture depth.
Inserting the Test Strip
1. Remove a C ® N test strip from
ONTOUR EXT
the bottle. Tightly close the bottle lid
immediately after you have removed the
test strip.
Apply Blood
You will see the Apply Blood screen. The
meter is now ready to test a blood drop.
HINT: After the test strip is inserted, if you do not apply
blood to the test strip within 3 minutes, the meter will
turn off. Remove the test strip and reinsert it to begin
a test.
strip from
ottle lid
emoved the
2. Hold the test strip with
the gray square end
facing toward the meter.
3. Insert the gray square
end firmly into the test
strip port until the meter
beeps.
13