Vga Port; Dvi-I Port - DFI Q7-100 User Manual

VGA Port

VGA
The VGA port is used for connecting a VGA monitor. Connect the monitor's 15-pin D-shell cable
connector to the VGA port. After you plug the monitor's cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place.
Chapter 2 Hardware Installation
Chapter 2

DVI-I Port

DVI-I
(DVI-D signal only)
The DVI-I port is used to connect an LCD monitor. This port supports DVI-D signal only.
Connect the display device's cable connector to the DVI-I port. After you plug the cable con-
nector into the port, gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure the display device in the Chipset menu ("North Bridge Configuration" submenu) of
the BIOS. Refer to chapter 3 for more information.
16
www.dfi.com