Rj45 Lan Ports; Universal Serial Bus Connectors - DFI Q7-100 User Manual

RJ45 LAN Ports

LAN 1
LAN 2
The onboard RJ45 LAN port allows the system board to connect to a local area network by
means of a network hub.
Chapter 2 Hardware Installation
Chapter 2

Universal Serial Bus Connectors

USB 1
USB 0
USB 3
USB 2
USB allows data exchange between your computer and a wide range of simultaneously acces-
sible external Plug and Play peripherals.
The system board is equipped with four onboard USB 2.0/1.1 ports. The USB 4-5 and USB 6-7
connectors allow you to connect 4 additional USB 2.0/1.1 ports. The additional USB ports may
be mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the
rear of the system chassis then insert the cable connector to a USB connector.
Wake-On-USB Keyboard
The Wake-On-USB Keyboard function allows you to use a USB keyboard to wake up a system
from the S3 (STR - Suspend To RAM) state. To use this function:
• Jumper Setting:
JP4 must be set to "2-3 On: +5V_standby". Refer to "USB Power Select" in this chapter for
more information.
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for 2 USB ports, the
+5V_standby power source of your power supply must support ≥1.5A. For 3 or
more USB ports, the +5V_standby power source of your power supply must sup-
port ≥2A.
17
USB 4-5 10 9
N.C.
Key
USB 6-7
GND GND
+Data +Data
-Data
-Data
VCC
VCC
2 1
www.dfi.com