1. Notice of Use Follow all instructions. All requirements should be followed before using this camera. The manufacturer is not responsible for any technical or typographical errors and reserves the rights to this manual without notice. Keep this document for future reference. ...
2. Product Overview The Plate-Capture Camera is a high-performance plate-capture camera, equipped with a 1/3” SONY CCD. The Plate-Capture Camera’s outstanding feature set ensures seamless integration and enhanced performance when used in conjunction with external License Plate Recognition (LPR) software. Outfitted with powerful 850 nm IR, the Plate-Capture Camera works perfectly even in total darkness to deliver clear plate images.
2.1 Camera Parts Definition Power connector Extendable sunshield Rain guard BNC connector Mount adjustment Tele/Wide adjustment screw Far/Near adjustment screw Rain guard/extendable sunshield: minimize the effects of rain and sunlight on image quality. Tele/Wide and Far/Near adjustment screws: lens adjustment ...
2.2 Specification Image system Signal system NTSC Image Sensor 1/3" SONY CCD Effective pixels(HxV) 768 x 494 752 x 582 Electric 2:1 Interlace V: 59.94Hz, 2:1 Interlace V: 50Hz, Scanning system H: 15.734KHz H: 15.625KHz Sync system Internal Horizontal resolution 600 TV lines f=9mm ~ 22mm, F1.4 DC iris varifocal IR-corrected lens Built-in lens...
Suggest the horizontal angle is less than 40 degree. This camera is designed to cover only one lane (less than 3 meters). If work with DVR, make sure your DVR has the de-interlace feature and the frame rate is above 15 fps for optimal effect. To ensure an optimal view, please adjust the lens under the limitation we suggest.
Page 10
2. loosen the right screw 3. rotate the mount adjustment 1. loosen the left screw Install the camera: use an appropriate tool to lock 3 self-tapping screws to fasten the camera. For static electricity protection, please use the rubber pad to cover the metal mount adjustment and put 3 insulation caps through the metal screws when locking 3 self-tapping screws into the desired location.
Page 11
4. Adjust the lens: Loosen the screws and make the Far/Near and Tele/Wide adjustments. After adjustments, make sure to tighten the screws to keep the camera waterproof. It’s suggested to manually tighten the screws. If using an electric screwdriver, a torque of 5~8 kgf-cm is suggested. Warning: please do not adjust the Tele/Wide or Warning: please don’t loosen these Far/Near screw out of the instruction line to avoid...