Step 1: Unpacking Treadmill - LifeSpan TR800 Owner's Manual

Step 1: Unpacking Treadmill

Cut packaging straps and remove.
A.
B. Remove the box top.
C. Remove small parts and packaging material and unwrap parts.
D. Cut corners of the bottom box and remove all packaging material to begin assembly. The
treadmill can be assembled in the box. No need to pick the treadmill up to remove it from box.
Step 2: Handlebar Support Post Assembly
A. Remove the screw (A) and nut (E) that are pre-assembled on the frame from each side of the
base using the 6 mm Allen wrench and 17 mm open end wrench provided in your tool kit.
These two screws will prevent the handlebars from rotating up into their upright position.
Note: Make sure the wire harness coming from the front of the frame to the base of the right
handlebar support will not be pinched when pivoting the right handlebar support up
into position.
B. Stand the support posts and handlebars up into their operating position and re-attach the
screws (A) and nuts (E) removed in step 2A. Tighten securely.
C. Attach the left (13) and right (14) base covers using a Phillips screwdriver and 2 machine screws (G)
on each side. The 4 base cover attaching screws are located in the hardware bag.
TR800 / TR1200i
E
A
G
13
Folding Treadmill
11