Table of Contents
Advertisement
Wall Mounting the Repeater/charger
If you want mount the charger on the wall, you need to adjust the
desk stand:
1. Pull the locking tab up and
back (see the black arrow in the
illustration to the right), and slide
the desk stand straight off.
2. Flip the stand over so the locking
tabs that say
charger with the arrows pointing
down.
3. Align the stand with the
notches on the charger.
4. Slide the stand onto the
notches until it clicks into
place.
5. Insert two #10 screws into the
wall, 30 mm apart. (For best
results, use a level to ensure
the screws are even.)
Remember to use
appropriate anchors for the
wall material.
6. Keeping the AC adapter cord
out of the way, place the
charger over the screw heads
and slide it down into place.
Switching back to the
desk stand
If you want to switch back to
using the charger on a desktop:
1. Remove the stand.
2. Rotate the stand so that the locking tabs that say
the charger with the arrows pointing up.
3. Align the stand with the notches on the charger.
4. Slide the stand onto the notches until it clicks into place.
are facing the
WAll
8
are facing
DESk
Advertisement
Table of Contents
