Painting The Speaker Grill; Installation - MartinLogan Electro Motion IC User Manual

P
ainting the
IMPORTANT! Before painting remove grill from
speakers. Also remove the cloth scrim attached
inside the grill.
1. Remove the grill from the speaker. A protec-
tive cloth scrim is attached to the back of
the grill with low-tack adhesive. Remove this
scrim by gently pulling it away from the grill.
2. Paint the grill, being careful not to plug the
holes. Allow the paint to completely dry before
proceeding. IMPORTANT! For best results
use a spray rather than a brush or roller.
i
nstaLLation
NOTE: These instructions assume the mounting sur-
face is of standard wood frame and standard sheet
rock construction. If you wish to mount the speakers
to another type of material you should contact a
bonded contractor.
NOTE: See your local dealer for new construction
pre-install brackets (sold separately).
WARNING!
check local building codes to
verify compliance with local regu-
lations. WARNING! Before install-
ing check for obstructions behind
drywall. To do this make a small
hole, cutting at a 45° angle (this
will make the hole easier to patch
if obstructions are found. Only cut
out the mounting hole after you
have verified there are no obstruc-
tions behind the dry wall. WARN-
ING! Use only speaker cable that
is rated for in-wall use. The UL stan-
dard is CL2, CL3, and CM. The
6
s g
Peaker riLL
Before installing
3. Gently press the scrim back into place before
reinstalling the speaker grill.
Fig. 6
CSA standard is FT4. WARNING!
Turn your amplifier off before mak-
ing or breaking any signal connec-
tions.
Fig. 7 ElectroMotion IC