Setting Up The Monitor; Attaching The Stand; Connecting Your Monitor - Dell UltraSharp 27 UP2715K User Manual

Setting Up the Monitor

Attaching the Stand

NOTE: The stand is detached from the monitor when it is shipped from the
factory.
NOTE: This stand attaching instruction is applicable for the stand shipped
with the monitor. For other mounting solutions (optional), please refer to
their respective set up instructions.
To attach the monitor stand:
1. Remove the monitor protective cover and place the monitor on it.
2. Fit the two tabs on the upper part of the stand to the groove on the
back of the monitor.
3. Press the stand down till it snaps into its place.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section, follow
the Safety Instructions.
To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
2. Connect the DP (DisplayPort) cables to the corresponding video port
on the back of your computer
NOTE: Do not use all the cables on the same computer.
Use all of the cables only when they are connected to different computers
with appropriate video systems.
22  Setting Up the Monitor
3