Product Specific Problems - Dell UltraSharp 27 UP2715K User Manual

Product Specific Problems

Problem
Screen image is
too small
Cannot adjust
the monitor with
the buttons on
the front panel
No Input Signal
when user
controls are
pressed
The picture does
not fill the entire
screen
Unable to see
Post-screen or
Vbios setting
Post/BIOS is
observed on
one side of the
screen.
56  Troubleshooting
Cause
Image is
centered on
screen, but does
not fill entire
viewing area
OSD does not
appear on the
screen
No picture,
the LED light is
white
The picture
cannot fill the
height or width
of the screen
May miss the
post screen or
Vbios setting
during boot up
The picture
cannot fill the
whole screen.
Solution
• Check the Aspect Ratio setting in
Display Settings OSD
• Reset the monitor to Factory
Settings.
• Turn Off the monitor, unplug the
power cord, plug back, and then turn
On the monitor.
• Check the signal source. Ensure the
Computer is not in the power saving
mode by moving the mouse or
pressing any key on the keyboard.
• Check to make sure Video Source
to DisplayPort or Mini DisplayPort or
HDMI is powered and playing video
media.
• Check whether the signal cable is
plugged in properly. Re-plug the
signal cable if necessary.
• Reset the computer or video player.
• Due to different video formats
(aspect ratio) of DVDs, the monitor
may display in full screen.
• Run the built-in diagnostics.
• Disable sleep mode in monitor and
reboot PC.
• Turn Off the Monitor Sleep in Energy
settings OSD, then reboot PC to
show the Post-screen or Vbios.
• This is expected behavior for some
graphics card. Full screen will be
displayed after graphics card driver is
loaded.