Table of Contents
Advertisement
12.2 VIP-UP PROGRAM
12.2.1 Running the VIP-UP Program
The VIP-UP program is TEKNOR's own setup program for enabling, disabling, and
relocating various hardware features.
During boot-up, hit the CTRL and V keys simultaneously, before or when you see the
message "Press CTRL-V to enter TEKNOR VIP-UP" at the top of the screen (CTRL-V will
work, even if the message display is disabled in VIP-UP). The VIP-UP program is also
provided on the utility disk.
At the DOS prompt, type "VIP-UP" and press ENTER.
TEKNOR MICROSYSTEMS INC
TEKNOR BIOS Extension Address
TEKNOR BIOS Window Address
BIOS Interrupt 13h Configuration
Flash Disk Support
On Board Ethernet
Enter VIP-UP Message
VT100 & Serial Download Speed
VT100 & Serial Download Serial Port
Use Flash To Store CMOS RAM SETUP
COM2 Operation Mode
↑ ↓
to select options
PgDn(+), PgUp(-) to change an option
↑
↓
1.
Use
and
keyboard keys to move up and down the screen, and on to subsequent or
preceding screens. As you do, the value of the selected field is highlighted.
2.
Press PgDn or the "+" key to increase a value.
3.
Press PgUp or the "-" key to decrease a value.
NOTE
Press F10 to save the current configuration and exit (type "U" in
VT100 mode). The configuration is not saved until F10 is pressed or
"U" is typed. Press ESC to exit without saving the setup.
--- TEK SETUP
CC000H-CFFFFH
E0000H-E3FFFH
Disabled
Not Installed
Enabled
Displayed 3 seconds
19200 BPS
COM1: 3F8H
No
RS-232
ESC - Quit without saving
F10 - (U)pdate Flash BIOS
12-13
Software Setup
Advertisement
Table of Contents
